This Module has another name: Gert -VGA-adapter, or Passive VGA adapter 666 for Raspberry Pi A+/B+/2B/3B/Zero. The Raspberry Pi has an HDMI port to connect a display. If your monitor only has VGA, you have to use an adapter. Because this requires a digital-to-analog conversion, those adapters can be quite pricey, and they can draw lots of power. As well as just allowing you to connect a VGA monitor natively. And unlike composite video, the DPI interface can be run independently of the HDMI. The software for dual screens is still under development. Running two screens at maximum resolution will depend on the speed of GPIO. This wasn’t possible on the Model A or B. And there’s a catch: as the board uses most of your GPIO pins, you lose access to them.
How to use it:
Edit /boot/config.txt file with vim.tiny or other editor. and modify as following:
framebuffer_width=800
framebuffer_height=600
dpi_group=2
device_tree=bcm2710-rpi-3-b.dtb
dpi_mode=86
dtparam=i2c_arm=off
dtparam=spi=off
dtparam=uart0=off
dtparam=uart1=off
dtoverlay=pi3-disable-bt-overlay
dtoverlay=vga666
enable_dpi_lcd=1
display_default_lcd=1
force_pwm_open=0
dtparam=audio=on
start_x=1
gpu_mem=128
Features:
- Support for Raspberry Pi 3B / 2B / B+ / A+
- The VGA output supports resolution:from 640 x 480 up to 1920 x 1024 at 60fps.
- With 6 bits per channel, you have a maximum of 262144 colors.
- Easy to setup.
- Easy to configure.
Package Includes:
1 x VGA666 RPI Dtoverlays Module
